Terms used to explain brushed and brushless motors


Terms used to explain brushed and brushless motors
Armature: The armature (or arm) is what spins in the motor and makes your rc helicopter move. It is made up of the commutator, laminations, shaft and winds. Electricity flows through the wires from the ESC to the end bell. It then travels through the brushes to the commutator, and into the windings on the arm. Since the windings are wrapped into a coil, they create a magnetic field when current is passed through them. This magnetic field is repelled and attracted to the magnets in the can causing the arm to turn. 

Brush: Made of a silver, copper, or graphite compound and at the end of the shunt wire. They are what makes contact with the commutator and transfer the electric current to the commutator. 

Commutator: Typically referred to as the Comm. The comm takes current from your brushes, which ride on this part of the arm, and sends it to the windings. The comm is not one solid piece, but is actually made up of 3 separate pieces. This allows the current to be switched to the different windings of the arm as it spins. Because it rubs against the brushes as the arm spins, the comm needs to be cleaned and shaped regularly. 

Continuous / Burst Current: Continuous current measures how much current a motor can handle continuously, for an extended period of time. Burst current measures how much current a motor can handle for a short amount of time, about a few seconds. 

Current Rating: This is the maximum current that a given motor can handle, measured in amps. 

Endbell: The part of the motor that consists of the brush hoods and the tabs. The endbell holds the bearing that supports the short end of the shaft. 

Kv Rating: The Kv number is the RPM per volt supplied to the motor. The KV number's useful because it let's you figure out how many volts you need to achieve a certain RPM, or vice versa. For example, a 1200 Kv motor, supplied with 3 volts, will run at a nominal 3600 rpm. The Kv rating always assumes no load on the motor, so the actual RPM that your achieve will be less than the one you calculate. Note that Kv is the voltage constant (capital-K, subscript v), not to be confused with the kilovolt, whose symbol is kV (lower-case k, capital V). 

Laminations: The part of the armature the winds are wrapped around. These are usually about half a millimeter thick, and are stacked on top of each other. The laminations are sometimes shaped to provide a stronger field. They are usually made of iron ferrite. 

Magnets: Provides the opposing force that the armature's magnetic force pushes against. 

RPM: This is a measure of angular speed, or how fast something is rotating. A motor's RPM is simply how fast it can rotate per minute. 

Torque: Torque is a measure of angular force, or how much "push" a rotating shaft has. 

Volt: This measures electric potential, or how much "push" the electrons from a battery have. A greater voltage means that more energy is being applied to a given amount of charge. 

Watt: This is a measure of power, or how fast energy is used.